VQT1T27
120
Connecting to other equipment
Select [CONVERSION] on the [REC] menu.
• Refer to P90 for [CONVERSION].
Press 3/4 to select [ ], and then press [MENU/SET] to set.
Note
•
When there is dirt (water, oil, and fingerprints, etc.) on the surface of the lens, the image may
be affected. Lightly wipe the surface of the lens with a soft, dry cloth before and after taking
pictures.
• When the wide conversion lens is removed, set [CONVERSION] to [OFF].
• When you take pictures at close range, the resolution of the periphery of the picture may
decrease slightly. This is not a malfunction.
• Refer to operating instructions of the wide conversion lens for details.
• Turn off the camera when removing the conversion lens.
• When the [CONVERSION] (P90) is set to [ ], the flash is fixed to [Œ].
Using the Protector/Filter
The MC protector (DMW-LMC46; optional) is a transparent filter which affects neither the
colors nor the amount of light, so it can always be used to protect the camera’s lens.
The ND filter (DMW-LND46; optional) reduces the amount of light to approximately 1/8th
(equal to adjusting the aperture value 3 increments) without affecting the color balance.
PL filter (DMW-LPL46; optional) will suppress the reflected light from a metal or non
spherical surfaces (flat non-metallic surfaces, water vapour or invisible particles in the air),
making it possible to take a picture with enhanced contrast.
Preparations: Turn off the camera and remove the lens cap.
Remove the lens ring front.
• Be careful not to lose the lens ring front.
Attach the lens adaptor.
• Rotate the lens slowly and carefully.
A Lens adaptor (DMW-LA4; optional)
Attach a filter.
B MC protector
C ND filter
D PL filter
P.PC_DMC-LX3_eng.book 120 ページ ２００８年７月８日 火曜日 午後１０時１３分
To Next Page
Loading...
