85
VQT1T27
Advanced (Recording pictures)
Applicable modes:
∫ Setting the AF/AE lock
1 Aim the AF area at the subject.
2 Press [AF/AE LOCK] to fix the focus and exposure.
3 Move the camera to compose the picture and then press the shutter button fully.
∫ To cancel the AF/AE lock
The setting is canceled by pressing the [AF/AE LOCK] again.
Note
•
Exposure is set even if the brightness of the subject changes in [AE].
• The subject can be focused again by pressing the shutter button halfway even when AE is
locked.
• Program shift can be set even when AE is locked.
• Lock is canceled when zooming is performed after locking. Perform the locking again.
For details on [REC] mode menu settings, refer to P21.
Contrast and exposure will be adjusted automatically when there is a big difference in
brightness between the background and subject, to bring the image close to how you see.
Applicable modes:
[OFF]/[LOW]/[STANDARD]/[HIGH]
Note
•
[LOW], [STANDARD], or [HIGH] represents the maximum range of effect.
• When it is set to [LOW], [STANDARD] or [HIGH], [ ] is displayed on the screen.
• When ISO sensitivity is set to [ISO80] or [ISO100], the ISO sensitivity might become higher
than [ISO80] or [ISO100] when the [I.EXPOSURE] is set.
• Compensation effect may not be achieved depending on the conditions.
• [ ] in the screen turns to yellow when [I.EXPOSURE] is in effect.
For details on [REC] mode menu settings, refer to P21.
Using this function, you can achieve the kind of effect that is obtained when an image is
exposed two or three times.
Applicable modes:
[AF]: Only the focus is locked.
•
[ ] is displayed when the focus is adjusted.
[AE]: Only the exposure is locked.
•
[ ], aperture value, and shutter speed is displayed when the exposure
is adjusted.
[AF/AE]: Both focus and exposure are locked.
•
[ ], aperture value, and shutter speed are displayed when the focus and
exposure are adjusted.
[I.EXPOSURE] (Intelligent exposure adjustment)
[MULTI. EXPO.]
P.PC_DMC-LX3_eng.book 85 ページ ２００８年７月８日 火曜日 午後１０時１３分
To Next Page
Loading...
