VQT1T27
88
Advanced (Recording pictures)
For details on [REC] mode menu settings, refer to P21.
You can take a picture brightly in dark places by setting [MIN. SHTR SPEED] slower. Also,
you can set it faster to reduce the blur of the subject.
Applicable modes:
[1/250], [1/125], [1/60], [1/30], [1/15], [1/8], [1/4], [1/2], [1]
Note
•
This should usually be set to [1/8] to take pictures. (When you select a minimum shutter speed
other than [1/8], [ ] appears on the screen.)
• Setting [MIN. SHTR SPEED] to slower speed might increase the chance of jitter, so we
recommend using a tripod and the self-timer for taking pictures.
• Setting [MIN. SHTR SPEED] to faster speed might make the picture darker, so we recommend
recording the picture in well-lit area. If correct exposure cannot be achieved, [ ] will flash in
red when the shutter button is pressed halfway.
For details on [REC] mode menu settings, refer to P21.
Audio can be recorded simultaneously with the image. You can record the conversation
during the shooting or the situation as a memo.
Applicable modes:
•
If you press [MENU/SET] during audio recording, the audio recording is canceled.
Note
•
Audio is recorded from the built-in microphone on the camera.
• Audio recorded with this unit may not playback on other equipment.
For details on [REC] mode menu settings, refer to P21.
Illuminating the subject makes it easier for the camera to focus when recording in low light
conditions that make focusing difficult.
Applicable modes:
[MIN. SHTR SPEED]
Minimum shutter speed setting 1/250– 1–
Brightness Darker Brighter
Jitter Less More
B [AUDIO REC.]
[OFF]: Audio will not be recorded.
[ON]: [B] is displayed on the screen.
Audio will be recorded as soon as the image is recorded.
(It will stop in 5 seconds)
F [AF ASSIST LAMP]
[OFF]: The AF assist lamp does not turn on.
[ON]: When taking pictures in dark places, the AF assist lamp lights while the shutter
button is pressed halfway. (Larger AF areas are now displayed.)
P.PC_DMC-LX3_eng.book 88 ページ ２００８年７月８日 火曜日 午後１０時１３分
To Next Page
Loading...
