VQT1T27
130
Others
Functions that cannot be set or will not work
under some conditions
Due to the camera’s specifications, it may not be possible to set some of the functions or
some functions may not work in some of the conditions under which the camera is used.
The table below lists these functions and the corresponding conditions.
[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
•
An error has occurred accessing the card.
> Insert the card again.
• Or try with a different card.
[READ ERROR
PLEASE CHECK THE CARD]
•
An error has occurred reading the data.
> Insert the card again.
[WRITE ERROR
PLEASE CHECK THE CARD]
•
An error has occurred writing the data.
> Turn the camera off and remove the card. Insert the card again and turn the camera on.
Make sure the camera is turned off before removing or inserting the card to avoid
damage.
• Or try with a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
•
When you set the picture quality to [ ], [ ] or [ ], we recommend using a high-speed
card with “10MB/s” or greater displayed on the package.
• Depending on the type of SD Memory Card or SDHC Memory Card, motion picture recording
may stop in the middle.
[A FOLDER CANNOT BE CREATED]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
(P112)
> Format the card after saving necessary data on a PC etc. (P28) If you execute
[NO.RESET] in the [SETUP] menu after formatting, the folder number is reset to 100.
(P26)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
•
The AV cable is connected to the camera.
> Press [MENU/SET] if you want to delete this message at once.
> Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P27)
• This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P110,
112)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
•
The printer cannot print.
> Check the printer.
P.PC_DMC-LX3_eng.book 130 ページ 2008年7月8日 火曜日 午後10時13分