I
Set a recording start and stop time. Or, set
a 5 or 10 second interval recording to be
done each minute.
Camera Recording
I
Before you begin...
• ConnectCamcorderto power source.
UseAC Adaptor for longer recordings,
• Insertcassettewith recordtab (page 15).
• Set POWERto CAMERA.
D
DISPLAY MENU
©o
4
_ IOMIN. _ 20MIN. -- 30MIN.--TO TAPE END -"7
INTERVAL'2 _ INTERVAL*I J
10 SEC/MIN. 5 SEC/MIN,
"1 Interval 5 SEC/MIN:
Record 5 seconds each minute.
*2 Interval 10 SEC/MIN:
Record t0 seconds each minute.
Note:
• Start time may not be set over 24 hours
from current time.
• Camcorder shuts off at tape end, or 12
hours after tntervat Recording starts.
• To cancel, set POWER to OFF,
4
Press DOWN V to select
r_'_r_. Press DISPLAY repeatedly to
select one of the options shown at
the left.
START; to:_ 1
CT: _U_0t YtA _Y I
ST_ : pIJN_ ItlE_OND _
10:_:0(iI_1
To eahcel the setup, press MENU
twice.
Press RECORD/PAUSE to place
Camcorder in stand-by mode.
_C TIME ; 10M_I.
tO:2Lt:0QPM
12QO0
Recording wilt be done as scheduled.
27
To Next Page
Loading...
