[DHCP] [OFF]
[IP ADDRESS] 192.168.10.100
[SUBNET MASK] 255.255.255.0
[DEFAULT GATEWAY] 192.168.10.1
[DNS1] / [DNS2] (Blank)
Operating the computer
1) Turn on the power of the computer.
2) Perform the network setting following the instruction of your network administrator.
f If the projector is in factory default setting, you can use it as it is if the network setting of the computer is as
follows.
[IP ADDRESS] 192.168.10.101
[SUBNET MASK] 255.255.255.0
[DEFAULT GATEWAY] 192.168.10.1
Connecting with wireless LAN
The wireless module (Model No.: AJ-WM50) of the optional accessories is required if you want to use the network
function through the wireless LAN.
Connection example
IEEE802.11b/g/n
Wireless module of optional accessories
(Model No.: AJ-WM50)
Preparation and conrmation of the projector
1) Turn on the projector.
2) Attach the wireless module (Model No.: AJ-WM50) of optional accessories firmly into the <USB
(VIEWER/WIRELESS/DC OUT)> terminal.
Wireless module of optional
accessories
(Model No.: AJ-WM50)
3) Press the <NETWORK/USB> button to switch to NETWORK input.
f The network input idle screen is displayed. The login password (a four-digit number that is automatically
generated), PROJECTOR NAME, SSID, IP ADDRESS (WIRELESS) and IP ADDRESS (WIRED) will be
displayed in the idle screen.
f You can also press the <INPUT SELECT> button on the control panel and the input guide is displayed, then
press asqw to switch to NETWORK input.
106 - ENGLISH
Chapter 5 Operation of Function - Network connection
To Next Page
Loading...
