[CONTROL DEVICE SETUP]
Enable/disable the button operations on the control panel and the remote control.
1) Press as to select [CONTROL DEVICE SETUP].
2) Press the <ENTER> button.
f The [CONTROL DEVICE SETUP] screen is displayed.
3) Press as to select one item between [CONTROL PANEL] and [REMOTE CONTROLLER].
[CONTROL PANEL]
You can limit the control method to the control panel.
[REMOTE CONTROLLER]
You can limit the control method to the remote control.
4) Press qw to switch between [ENABLE] and [DISABLE].
f You can limit the control method to the control panel or the remote control.
[ENABLE]
Enable the operation of all buttons.
[DISABLE]
Disable the operation of all buttons.
f When you change [ENABLE] to [DISABLE], proceed to Step 5).
5) When the confirmation screen is displayed, press qw to select [OK], and then press the <ENTER>
button.
Note
f When a button operation is performed on the device set to [DISABLE] , the [PASSWORD] screen is displayed.
To continue operations, enter the security password.
f The [PASSWORD] screen will disappear when there is no operation for approx. 10 seconds.
f If the operations of both [CONTROL PANEL] and [REMOTE CONTROLLER] are set to [DISABLE], the projector cannot be turned off
(cannot enter standby).
f Even when you set button operations on the remote control to be disabled, operations of the <ID ALL> and <ID SET> buttons on the remote
control are enabled.
94 - ENGLISH
Chapter 4 Settings - [SECURITY] menu
To Next Page
Loading...
