Panasonic PT-VMZ50

2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select the items of [AUDIO IN SELECT] to set.
[COMPUTER1]
Set the audio output for COMPUTER1 input.
[COMPUTER2]
Set the audio output for COMPUTER2 input.
[VIDEO]
Set the audio output for VIDEO input.
[HDMI1]
Set the audio output for HDMI1 input.
[HDMI2]
Set the audio output for HDMI2 input.
[DIGITAL LINK]
Set the audio output for DIGITAL LINK input.
[MEMORY VIEWER]
Set the audio output for MEMORY VIEWER input.
[NETWORK]
Set the audio output for NETWORK input.
4) Press qw to switch the item.
f The sub items will switch each time you press the button.
[AUDIO IN 1]
Audio connected to the <AUDIO IN 1> terminal is output during projection of image from the set input
terminal.
[AUDIO IN 2]
Audio connected to the <AUDIO IN 2> terminal is output during projection of image from the set input
terminal.
[AUDIO IN 3]
Audio connected to the <AUDIO IN 3> terminal is output during projection of image from the set input
terminal.
[HDMI1 AUDIO IN]
*1
Audio input to HDMI1 is output.
[HDMI2 AUDIO IN]
*2
Audio input to HDMI2 is output.
[DIGITAL LINK AUDIO IN]
*3
Audio input to DIGITAL LINK is output.
[NETWORK AUDIO IN]
*4
Audio input to NETWORK is output.
*1 Only for HDMI1 input.
*2 Only for HDMI2 input.
*3 Only for DIGITAL LINK input.
*4 Only for NETWORK input.
[TEST PATTERN]
Displays the test pattern built-in to the projector.
The settings such as [CONTRAST] or [BRIGHTNESS] that can be set from the [PICTURE] menu will not be
reected in the test pattern. Make sure to perform various adjustments with input signals displayed.
1) Press as to select [TEST PATTERN].
2) Press the <ENTER> button.
f The ALL WHITE test pattern is displayed.
3) Press qw to switch the test pattern.
f The test pattern will switch each time you press the button.
All white
The test pattern is displayed together with the operation guide of [PATTERN SELECT]. Select your
desired test pattern.
Color bar (Vertical)
Color bar (Horizontal)
Cross
Cross (Inversion)
Cross hatch
Note
f If [TEST PATTERN] is assigned to the <FUNCTION> button on the remote control, the all white pattern will be displayed after pressing the
<FUNCTION> button.
[FILTER COUNTER]
This function is used to check the usage time of the air lter or set the cleaning/replacement cycle of the air lter.
Also, you can reset the air lter usage time.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
90 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu