Panasonic PT-VMZ50

r Response data
String Details
Termination symbol
Message
"ERR1" Undened control command
(CR)
0x0d
"ERR2" Out of parameter range
"ERR3" Busy state or no-acceptable period
"ERR4" Timeout or no-acceptable period
"ERR5" Wrong data length
"ERRA" Password mismatch
Data length
4 bytes ― 1 byte
Note
f The projector automatically disconnects from the network immediately after sending the command. Such specications are made from the
viewpoint of security, such as prevention of illegal operation of the projector by a malicious third party. To send commands continuously,
make a request for network connection every time and send it. For details, see “Communication ow between the server and the client”
(x page 137).
Communication ow between the server and the client
When sending / receiving commands via LAN, refer to the communication ow shown below.
Server: the projector
Client: the control device such as a computer
Client
Server
First session
Second session
Connection query
Sending key
Send rst command
Respond rst command
Cut off
Connection query
Sending key
Send second command
Respond second command
Cut off
ENGLISH - 137
Chapter 7 Appendix - Technical information