3
4
2
1
5
r Top
r Bottom
: Projection direction
1 Ambient luminance sensor
2 Vertical lens shift dial
Adjusts the projecting position in the vertical direction (vertical
shift).
3 Control panel (x page 27)
4 Horizontal lens shift dial
Adjusts the projecting position in the horizontal direction
(horizontal shift).
5 Burglar hook port
Attaches a burglar prevention cable, etc.
Attention
f Do not block the ventilation ports (intake and exhaust) of the projector.
The components may deteriorate faster if cooling inside the projector is inhibited.
r Control panel
1 Power button <v/b> (v Standby / b Power on)
Sets the projector to the state where the projector is switched
off (standby mode). Also starts projection when the power is
switched off (standby mode).
2 <VOL
-
> button / <VOL+> button
Adjusts the volume of the built-in speaker or audio output.
(x page 53)
3 <MENU> button
Displays or hides the main menu. (x page 59)
When the sub menu is displayed, pressing it will return to the
previous screen.
4 <ENTER> button
Determines and executes an item in the menu screen.
5 <INPUT SELECT> button
Switches the input signal to project. (x page 48)
6 <SHUTTER> button
Used to turn off the audio and video temporarily. (x page 52)
Used to automatically adjust with auto setup function while
projecting the image (x page 53). It is also used to operate the
Memory Viewer screen.
8 asqw buttons
Used to select the menu screen items, switch the setting or
adjust the level.
Also used to enter a password in the [SECURITY] menu or enter
characters.
ENGLISH - 27
Chapter 1 Preparation - About your projector
To Next Page
Loading...
