Zoom ring (Back)1
Adjust the zoom.
Control Panel and Indicators (2
Æ
page 22)
Lamp cover (3
Æ
page 97)
The lamp unit is located inside.
Projection Lens4
Focus ring (Front)5
Adjust the focus.
Remote control signal receiver6
Air exhaust port7
Speaker8
<AC IN> terminal 9
Connect the supplied power cord.
Rear terminals (10
Æ
page 22)
Air intake port / Air lter cover (11 Æpage 95)
The air lter unit is inside.
Adjustable feet 12
Adjust the projection angle.
Security Chain Hook 13
Attaches a burglar prevention cable, etc.
Note
The remote control can be used within a distance of about 7 m (22.97') if pointed directly at the remote control signal f
receiver. The remote control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control
range may be reduced.
If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not f
operate correctly.
You can operate the projector by reecting the remote control signal on the screen. The operating range may differ due to f
the loss of light caused by the properties of the screen.
When the remote control signal receiver is lit with a uorescent light or other strong light source, the projector may become f
inoperative. Set the projector as far from the luminous source as possible.
Projector body
1
5
6
4
2
3
7
11
9
10
12
WARNING
Keep your hands and other objects away from the air exhaust port.
Keep your hand and face away. f
Do not insert your nger. f
Keep heat-sensitive articles away. f
Heated air from the air exhaust port can cause burns or external damage.
13
Attention
Do not block the ventilation ports (intake and exhaust) of the projector. f
8
ENGLISH - 21
Chapter 1 Preparation - About your projector
To Next Page
Loading...
