[NETWORK] menu
On the menu screen, select [NETWORK] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (Æpage 45) for the operation of the menu screen.
After selecting the item, press f asqw to set.
[WIRED LAN]
You can make detailed wired LAN settings.
Press 1) as to select [WIRED LAN].
Press the <ENTER> button.2)
The [WIRED DETAILED SETUP] screen is displayed. f
Press 3) as to select an item, and change the setting according to the instructions.
[DHCP]
[ON]: If a DHCP server exists in the network to which the projector is connected,
the IP address will automatically be acquired.
[OFF]: If a DHCP server does not exist in the network to which the projector is
connected, additionally set [IP ADDRESS], [SUBNET MASK] and
[DEFAULT GATEWAY].
[IP ADDRESS] Enter the IP address if DHCP server is not used.
[SUBNET MASK] If not using a DHCP server, enter the subnet mask.
[DEFAULT GATEWAY] Enter the gateway address if DHCP server is not used.
[DNS1] Enter the DNS server address if DHCP server is not used.
[DNS2] Enter the alternate DNS server address if DHCP server is not used.
Press 4) as to select [OK], and press the <ENTER> button.
Default wired LAN settings r
The following settings are set before the projector leaves the factory. f
[DHCP] OFF
[IP ADDRESS] 192.168.10.10 0
[SUBNET MASK] 255.255.255.0
[DEFAULT GATEWAY] 192.168.10.1
[DNS1] / [DNS2] NONE
Note
When using a DHCP server, conrm that the DHCP server is running. f
Consult your network administrator regarding the IP ADDRESS, SUBNET MASK, and DEFAULT GATEWAY. f
76 - ENGLISH
Chapter 4 Settings - [NETWORK] menu
To Next Page
Loading...
