Error information page
When [Error (Detail)] or [Warning (Detail)] is displayed in the self-diagnosis display of the [Projector status] screen, click it to
display the error/warning details.
The projector may go into the standby status to protect the projector depending on the contents of the error. f
Self-diagnosis result display1
Displays the item check results.
[OK]: Indicates that operation is normal.
[FAILED]: Indicates that there is a problem.
[WARNING]: Indicates that there is a warning.
[FAILED] items displayed when a problem occurs r
Parameter Description
[FAN] Trouble has occurred in the fan or its drive circuit. Consult your dealer.
[FAN(INTAKE)] Trouble has occurred in the intake fan.
[FAN(EXHAUST)] Trouble has occurred in the exhaust fan.
[FAN(LAMP)] Trouble has occurred in the lamp cooling fan.
[INTAKE AIR TEMPERATURE]
The air intake temperature is too high. The projector may be used in an operating
environment where the temperature is high, such as near a heating appliance.
[EXHAUST AIR TEMPERATURE] The exhaust air temperature is high. The air exhaust port may be blocked.
[OPTICS MODULE TEMPERATURE]
The temperature around the optics module inside the projector is high. The projec-
tor may be used in an operating environment where the temperature is high, such
as near a heating appliance.
[LAMP REMAIN TIME]
The lamp runtime has exceeded the prescribed cumulative time, and it is now time
to replace the lamp.
[LAMP STATUS]
The lamp has failed to light.
Wait a short while for the lamp to cool off, and then turn on the power.
[APERTURE (CONTRAST-SHUTTER)] Trouble has occurred in the contrast shutter circuitry. Consult your dealer.
[AIR FILTER]
There is too much dust accumulated in the air lter unit. Turning off the projector
and clean the air lter unit.
[Network status] page
Click [Status] → [Network status].
The current network setting status is displayed.
82 - ENGLISH
Chapter 4 Settings - [NETWORK] menu
To Next Page
Loading...
