The items will switch each time you press the button. f
[OFF] Disables audio output in the standby mode.
[ON]
Enables audio output in the standby mode when [STANDBY MODE] is set to [NORMAL]. At this time, press
the <VOL - / VOL +> buttons on the remote control or qw buttons on the control panel to adjust the volume.
Note
Audio cannot be output during standby when [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] f or [NETWORK] (
Æ
page 69).
Setting audio input selection
Choose the audio input terminal for each input signal.
Press 1) as to select [AUDIO SETTING].
Press the <ENTER> button.2)
The [AUDIO SETTING] screen is displayed. f
Press 3) as to select one item of [AUDIO IN SELECT].
[COMPUTER1] Set the audio output when [COMPUTER1] input is selected.
[COMPUTER2] Set the audio output when [COMPUTER2] input is selected.
[VIDEO] Set the audio output when [VIDEO] input is selected.
[S-VIDEO] Set the audio output when [S-VIDEO] input is selected.
[HDMI] Set the audio output when [HDMI] input is selected.
Press 4) qw to switch the item.
The sub items will switch each time you press the button. f
[COMPUTER1] Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[COMPUTER2] Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[VIDEO] Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[S-VIDEO] Select one item among [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
[HDMI] Select one item among [HDMI AUDIO IN], [AUDIO IN 1], [AUDIO IN 2] or [AUDIO IN 3].
Note
When [MIC] is set to [ON], [AUDIO IN 2] cannot be selected. f
Even if [AUDIO IN 2] is selected, it will change to [AUDIO IN 1] automatically when [MIC] is set to [ON]. f
Using MIC function
Press 1) as to select [AUDIO SETTING].
Press the <ENTER> button.2)
The [AUDIO SETTING] screen is displayed. f
Press 3) as to select [MIC].
Press 4) qw to switch the items.
The items will switch each time you press the button. f
[ON] <AUDIO IN 2> terminal switch to MIC input.
[OFF] MIC is disabled.
Press 5) as to select [MIC GAIN].
Press 6) qw to adjust the level.
Operation Adjustment Range
Press the w button.
Turns up the MIC mixing gain.
0 ~ 63
Press the q button.
Turns down the MIC mixing gain.
Note
When [OFF] is selected in MIC function, the MIC GAIN function is not available. f
If the MIC function is set to [ON] when connecting audio signals to the <AUDIO IN 2 (MIC IN)> terminal, loud sound may be f
output suddenly depending on the setting value of [MIC GAIN].
When [MIC] is set to [ON], no signal is input, AV MUTE function is on, FREEZE function is on or the POWER f
MANAGEMENT function is working, the audio of MIC will be output.
ENGLISH - 71
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
