Note
Pressing the <MENU> button or <RETURN> button while the menu screen is displayed returns to the previous menu. f
Some items may not be adjusted or used for certain signal formats to be input to the projector. The menu items that cannot f
be adjusted or used are shown in gray characters, and they cannot be selected. [DIGITAL CINEMA REALITY] and [FRAME
LOCK] may not be displayed depending on the input signal.
Some items can be adjusted even if signals are not input. f
Individual adjustment screen is cleared automatically if no operation is performed for approximately ve seconds. f
For menu items, refer to “Main menu” ( f
Æpage 46) and “Sub-menu” (Æpage 47).
Resetting adjustment values to the factory default
If the <DEFAULT> button on the remote control is pressed, the values adjusted in the menu items are restored to the factory
default settings.
button
Press the <DEFAULT> button on the remote control.1)
Note
You cannot reset all the settings to the factory default at a time. f
To reset all the settings adjusted in the sub-menu item to the factory default one at a time, execute [PROJECTOR SETUP] f
menu → [INITIALIZE ALL] (
Æ page 72).
Some items cannot be reset by pressing the <DEFAULT> button. Adjust each item manually. f
Main menu
The main menu consists of the following 7 menu items.
When a main menu item is selected, the screen changes to a submenu selection screen.
Main-menu item Page
[PICTURE]
49
[POSITION]
54
[LANGUAGE]
59
[DISPLAY OPTION]
60
[PROJECTOR SETUP]
66
[SECURITY]
73
[NETWORK]
76
46 - ENGLISH
Chapter 4 Settings - Menu Navigation
To Next Page
Loading...
