[PROJECTOR SETUP] menu
On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (
Æpage 45) for the operation of the menu screen.
After selecting the item, press f asqw to set.
[STATUS]
You can check the using status of the projector.
Press 1) as to select [STATUS].
Press the <ENTER> button.2)
The [STATUS] screen is displayed. f
[SIGNAL]
[NAME] Displays the name of input signal.
[FREQUENCY] Displays the scanning frequency of input signal.
[RUNTIME]*
1
[PROJECTOR] Displays the current usage time of projector.
[LAMP
(ET-)]
[NORMAL]
[ECO1]
[ECO2]
Displays the operation time of lamp in each mode (NORMAL/ECO1/
ECO2). It may differ from the actual runtime under the each setting of
[NORMAL]/[ECO1]/[ECO2] in [LAMP POWER] menu.
And, displays the model no. of the replacement lamp unit for this
projector.
[SERIAL NUMBER] [PROJECTOR] Displays the serial number of the projector.
The following conversion is required to calculate the rough estimate for lamp replacement.*1
Formula for lamp replacement time (rough estimate)
A x 1 + B x 0.8 + C x 2/3
A : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [NORMAL] f
B : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [ECO1] f
C : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [ECO2] f
[COMPUTER2 SELECT]
Set whether to use the <COMPUTER 2 IN/1 OUT> terminal.
Press 1) as to select [COMPUTER2 SELECT].
Press 2) qw to switch the item.
The items will switch each time you press the button. f
[COMPUTER2 IN] When input the computer signal.
[COMPUTER1 OUT] Outputs the signal which have been input <COMPUTER 1 IN> terminal.
Note
The [COMPUTER2 SELECT] will be unavailable when COMPUTER2 is selected as input source. f
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side to enable
simultaneous control or individual control via a single remote control.
Press 1) as to select [PROJECTOR ID].
Press the <ENTER> button.2)
The [PROJECTOR ID] screen is displayed. f
66 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
