[SECURITY] menu
On the menu screen, select [SECURITY] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (
Æpage 45) for the operation of the menu screen.
When the projector is used for the rst time Initial password: Press f awsqawsq in order, and press the <ENTER>
button.
After selecting the item, press f asqw to set.
Attention
When you select the [SECURITY] menu and press the <ENTER> button, entering a password is required. Enter the preset f
password and then continue operations of the [SECURITY] menu.
When the password has been changed previously, enter the changed password, and press the <ENTER> button. f
Note
The entered password is displayed with " f " mark on the screen.
An error message is displayed on the screen when the entered password is incorrect. Re-enter the correct password. f
[PASSWORD]
The [PASSWORD] screen is displayed when the power is turned on, [INITIALIZE ALL] is executed or [INITIALIZE] in the
[NETWORK] is executed. When the entered password is incorrect, the operation will be restricted to the power standby <v/b>
button on the control panel or the remote control.
Press 1) as to select [PASSWORD].
Press 2) qw to switch the item.
The items will switch each time you press the button. f
[OFF] Disables the security password entry.
[ON] Enables the security password entry.
Note
The [PASSWORD] setting is set to [OFF] by the factory default. f
Change the password periodically that is hard to guess. f
The security password is enabled after setting [PASSWORD] to [ON] and turning the power off. f
[PASSWORD CHANGE]
Change the security password.
Press 1) as to select [PASSWORD CHANGE].
Press the <ENTER> button.2)
The [PASSWORD CHANGE] screen is displayed. f
Press 3) asqw or number buttons (<1>-<6>) to set the password.
Up to eight button operations can be set. f
Press the <ENTER> button.4)
Re-enter the password for the confirmation.5)
Press the <ENTER> button.6)
ENGLISH - 73
Chapter 4 Settings - [SECURITY] menu
To Next Page
Loading...
