[NETWORK] menu
On the menu screen, select [NETWORK] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (
Æpage 45) for the operation of the menu screen.
After selecting the item, press f asqw to set.
[WIRED LAN]
You can make detailed wired LAN settings.
Press 1) as to select [WIRED LAN].
Press the <ENTER> button.2)
The [WIRED DETAILED SETUP] screen is displayed. f
Press 3) as to select an item, and change the setting according to the instructions.
[DHCP]
[ON]: If a DHCP server exists in the network to which the projector is connected,
the IP address will automatically be acquired.
[OFF]: If a DHCP server does not exist in the network to which the projector is
connected, additionally set [IP ADDRESS], [SUBNET MASK] and
[DEFAULT GATEWAY].
[IP ADDRESS] Enter the IP address if DHCP server is not used.
[SUBNET MASK] If not using a DHCP server, enter the subnet mask.
[DEFAULT GATEWAY] Enter the gateway address if DHCP server is not used.
[DNS1] Enter the DNS server address if DHCP server is not used.
[DNS2] Enter the alternate DNS server address if DHCP server is not used.
Press 4) as to select [OK], and press <ENTER> button.
Default wired LAN settings r
The following settings are set before the projector leaves the factory. f
[DHCP] OFF
[IP ADDRESS] 192 .168.10.10 0
[SUBNET MASK] 255.255.255.0
[DEFAULT GATEWAY] 192.168.10.1
[DNS1]/[DNS2] NULL
Note
When using a DHCP server, conrm that the DHCP server is running. f
Consult your network administrator regarding the IP ADDRESS, SUBNET MASK, and DEFAULT GATWAY. f
76 - ENGLISH
Chapter 4 Settings - [NETWORK] menu
To Next Page
Loading...
