[CLOCK PHASE]
(Only for computer (RGB) signals input)
You can adjust to achieve an optimal image when there is a ickering image or smeared outlines.
Press 1) as to select [CLOCK PHASE].
Press 2) qw or the <ENTER> button.
The [CLOCK PHASE] individual adjustment screen is displayed. f
Press 3) qw to adjust the value.
The adjustment value are -16 to +16. Adjust so that the amount of interference is at a minimum. f
Note
Certain signals may not be adjustable. f
Optimal value may not be achieved if the output from the input computer is unstable. f
To project a signal with dot clock frequency with 162 MHz or higher, noise may not disappear even if [CLOCK PHASE] is f
adjusted.
[CLOCK PHASE] cannot be adjusted when a digital signal is input. f
[OVER SCAN]
Use this function when characters or pictures are cropped near the periphery of the projected image.
Press 1) as to select [OVER SCAN].
Press 2) qw or the <ENTER> button.
The [OVER SCAN] individual adjustment screen is displayed. f
Press 3) qw to adjust the level.
The adjustment value are 0 to +3. f
Note
It is unavailable for still images signals and HDMI signals. f
56 - ENGLISH
Chapter 4 Settings - [POSITION] menu
To Next Page
Loading...
