[SHIFT]
(Only for computer signals input)
Move the image position vertically or horizontally if the image position projected on the screen is shifted even when the relative
position of the projector and the screen is installed correctly.
Press 1) as to select [SHIFT].
Press the <ENTER> button.2)
The [SHIFT] screen is displayed. f
Press 3) asqw to adjust the position.
Orientation Operation Adjustment
Vertical (up and down)
adjustment.
Press the
a button.
The image position moves up.
Press the
s button.
The image position moves down.
Horizontal (right and left)
adjustment.
Press the
w button.
The image position moves to the
right.
Press the
q button.
The image position moves to the
left.
[DOT CLOCK]
(Only for still image computer (RGB) signals input)
Use this function to adjust and minimize the effect of interference caused by projection of patterns consisting of vertical stripes.
The projection of the following striped pattern may cause cyclic patterns (noise). Adjust so that the amount of interference is at
a minimum. You can adjust the dot lock of image.
Press 1) as to select [DOT CLOCK].
Press 2) qw or the <ENTER> button.
The [DOT CLOCK] individual adjustment screen is displayed. f
Press 3) qw to adjust the value.
The adjustment value are -32 to +32. f
Attention
Set it before adjusting [CLOCK PHASE]. f
ENGLISH - 55
Chapter 4 Settings - [POSITION] menu
To Next Page
Loading...
