Panasonic WJ-ND400 - Checking the IP Address

Using the Front Panel for Operations
42
You can check the DHCP, IP address, subnet mask, gateway
*
, and HTTP port
*
for each port. The following ports are displayed: Camera port: PT
#1, Client PC port (PC port): PT #2, and the Maintenance port: PT#3.
Use the arrow buttons (left or right) to switch between ports.
*Gateway and HTTP port settings are checked under the client PC port (PT #2).
The following shows the initial default values for the recorder network settings.
Check the settings by switching between screens using the following operations.
The LCD changes as follows when using the arrow buttons (up or down).
Checking the IP Address
Item Camera port Client PC port Maintenance port
DHCP − OFF −
IP address 192.168.0.250 192.168.1.250 192.168.2.250
Subnet mask 255.255.255.0 255.255.255.0 255.255.255.0
Gateway − 192.168.1.1 −
HTTP port − 80 −
[SET]
[ESC]
ND400_Basic.book 42 ページ ２００８年７月１０日 木曜日 午前１０時５０分