31
Basics
Configure the system settings to operate the recorder.
Use the following procedure to configure basic system settings.
1 Click the [Basic] button on the setup menu.
2 On the sub-menu that appears, click [Basic].
This will display the setting window.
3 Configure the settings for each item.
Refer to “Basic setup” table for details about the settings.
4 Click the [Set] button.
Basic setup
♦Initial default
Basics
Item Settings Description
Recording Off / On♦ Specifies whether recording should be performed.
• Recording is not performed when [Off] is selected. Select
[On] for this setting except to force a recording to stop.
LCD setup lock Off♦ / On Locks front panel buttons to prevent them from being operated.
• When [On] is selected, buttons can be unlocked by entering
a password, but they will re-lock automatically if no operation
is performed for a certain period of time (about one minute).
Password Enter password
(12345♦)
Specifies a password for releasing LCD setup lock. Sets the
password of five single-byte characters long.
Language Japanese / English♦ / Français /
Español / Deutsch / Italiano /
Russian / Chinese
Specifies the language used in browser screens.
Go to last before 5s / 10s / 30s♦ / 1min / 5min Specifies the time the image is displayed when the [Go to last]
button is clicked on the operation window.
Buzzer Off / 2s♦ / 5s / 10s / 20s / 30s /
1min / Ext
Specifies the duration that the buzzer sounds whenever an
error occurs on the recorder.
• Selecting [Ext] causes the buzzer to continue to sound until
the [ERR] button is clicked or the [BUZZER STOP] button on
the front panel is pressed.
Error output duration Off / 2s♦ / 5s / 10s / 20s / 30s /
1min / Ext
Specifies the duration of the error output whenever an error
occurs on the recorder. For details about error output, refer to
the Installation Guide.
• Selecting [Ext] causes signal output to continue until the
[ERR] button is clicked.
Safe shutdown time 10s♦ / 20s / 30s / 1min / 2min /
3min / 4min / 5min
Specifies the time until shutdown starts after a power down
detection signal is input to the recorder.
To Next Page
Loading...
