Camera
53
Use the following procedure to configure settings for automatically switching the camera image in a preset sequence.
1 Click the [Camera] button on the setup menu.
2 Click the [Sequence] tab.
This will display the "Sequence Setting" window.
3 Configure the settings for each item.
Refer to “Sequence display type settings” table for details
about the settings.
• Clicking the [Setup >>] button will display an advanced
settings window for the selected sequence.
4 Click the [Set] button.
Note:
• You must change the camera number when you change the 4-screen live sequence display (page 50).
• When the camera image compression format specified for the selected camera channel is MPEG-4, the image is skipped and the next image
is displayed.
Sequence
To Next Page
Loading...
