Panasonic WJ-NV200K - Page 45

45
Change the registered information [Registered information]
Click the [Setup >] button for "Change the registered information" on the [Camera registration] tab to display the following items.
After editing the settings, click the [OK] button to save the settings and return to the [Camera registration] tab.
[Camera]
Up to 16 cameras can be connected.
[Model]
Display the model of a registered network camera. (Blank:
Camera is not registered)
Click the [C] button to select the camera model from the
camera categories. Refer to the "readme.txt" on the provid-
ed CD-ROM for camera categories.
It is unnecessary to change it for normal use.
[IP address]
An IP address already in use will be displayed. Click the [C]
or [D] button to change the address.
[Compression]
Select the image compression method.
H.264/ MPEG-4/ MJPEG/ None
Default: None
Note:
 • Whenselectinganimagecompressionmethodother
than "H.264", the live image transmission rate and the
frame rate will be changed automatically to "5 ips".
(☞ Page 50)
 • Whenselecting"MPEG-4"ascompressionmethod,the
image size will be changed automatically to "VGA".
(☞ Page 52)
 • Dependingonthemodelofthecamera,thecameramay
restart when the compression method is changed. The
restart will be detected as a communication error, but
that is not a malfunction.
[User name]
Enter the user name for accessing the cameras and logging
in using the on-screen keyboard. (☞ Page 36)
Default: None
[Password]
Enter the password to be used for accessing the cameras
and logging in using the on-screen keyboard. (☞ Page 36)
(Up to 32 alphanumeric characters)
Default: None
[Port No.]
Set a port number from 1 - 65535 for use by the camera.
Default: 80
[Table to delete]
To delete registration information or remove a previously
connected camera, either select the camera number and
click the [Delete] button, or change the IP address of the
respective camera to "000.000.000.000".