It is possible to adjust the angular field of view using the extra zoom function.
• : Click this button to adjust the zoom ratio to the “Wide” side.
•
: Click this button to set the zoom ratio to x1.0.
• : Click this button to adjust the zoom ratio to the “Tele” side.
•
: Click these buttons to adjust the horizontal/vertical position of the image after zooming.
Note
• The supported extra optical zoom ratios vary depending on the model and the selected [Image capture
mode].
• For information about the maximum zoom ratio, refer to the Important Information.
IMPORTANT
• The positions will move out of alignment if extra zoom settings are configured when the mask area
(®page 106), privacy zone (®page 117), or VMD area (®page 138) is configured. To prevent this,
perform the setting for the extra zoom function before other settings.
116 Operating Instructions
2 Settings
To Next Page
Loading...
