2.9.3 How to configure HTTPS settings
The settings relating to the HTTPS protocol that can enhance the network security by encrypting the access
to cameras on this page.
HTTPS settings can be configured by either using the certificate pre-installed to the camera, or using a CA
certificate that you obtained by yourself from the CA (CA: Certification Authority). The settings will be configured
in the following procedure.
When using a pre-installed certificate: When using a CA certificate:
When a pre-installed certificate is selected When a CA certificate is
selected
Generate CSR (Certificate Signing Request)
(®page 79)
Apply for the approval and the issue of CA
certificate by CA
(®page 79)
Obtain the root certificate
(®page 175)
Install the CA certificate
(®page 184)
Configure HTTPS connections
(®page 181)
Access a camera using HTTPS Access a camera using HTTPS
When a pre-installed certificate is
selected
(®page 185)
When a CA certificate is
selected
(®page 190)
174 Operating Instructions
2 Settings
To Next Page
Loading...
