2.3.2.1 Configure the schedule/alarm (event function type setup menu)
Here, select the function type of the event.
[Trigger]
• Alarm: Select when setting the alarm detection settings.
• Schedule: Select during “SD memory recording” or “FTP periodic image transmission”.
• Default: Alarm
[SD memory card format]
To format the SD memory card, click the [Execute] button.
Once you click the [Execute] button, the “Format” confirmation screen will be displayed.
If you click the [OK] button, the formatting will start.
Once the “Format” completion screen is displayed, press the button.
IMPORTANT
• All data saved on the SD memory card will be deleted when the SD memory card is formatted.
• Do not turn off the power of the camera during formatting.
[Next] button
If you select “Alarm”, and click the [Next] button, the alarm setup menu will be displayed. (®page 49)
If you select “Schedule”, and click the [Next] button, the schedule function type setup menu will be displayed.
(®page 57)
2.3.2.2 Alarm: Configure the terminal and VMD (alarm setup menu)
The settings relating to actions when an alarm is detected can be configured in this section.
Operating Instructions 49
2 Settings
To Next Page
Loading...
