2.5.3 Configure the settings relating to Stream [Image]
Click the [Image] tab on the “Image/Audio” page. (®page 41, page 42)
Configure the settings relating to H.265 (or H.264) image such as “Max bit rate (per client)”, “Image capture
size”, “Image quality”, etc. in this section. Refer to page 87 for the settings relating to JPEG images.
Stream(1)/Stream(2)/Stream(3)/Stream(4)
[Stream transmission]
Select “On” or “Off” to determine whether or not to transmit H.265 (or H.264) images.
• On: Transmits H.265 (or H.264) images.
• Off: Does not transmit H.265 (or H.264) images.
• Default: On
Note
• When “On” is selected for “Stream transmission” in “Stream(1)”, “Stream(2)”, “Stream(3)”, or
“Stream(4)” displaying of H.265 (or H.264) images or JPEG images on the “Live” page will become
available.
• When “On” is selected for “Stream transmission” for “Stream(1)”, “Stream(2)”, “Stream(3)”, or
“Stream(4)”, the refresh interval of JPEG images is limited to a maximum of 5 fps.
[Stream encoding format]
Select the stream encoding format for transmission.
• H.265: Transmits H.265 images.
• H.264: Transmits H.264 images.
• Default: H.265
[Internet mode (over HTTP)]
Select “On” when transmitting H.265 (or H.264) images via the Internet. It is possible to transmit stream without
changing the broadband router settings configured for JPEG image transmission.
Operating Instructions 89
2 Settings
To Next Page
Loading...
