Category Indication Description
SD memory card
<SD> Format Successfully formatted the SD memory card.
<SD> Format error Error occurred when formatting the SD memory card.
<SD> Write-protect ON
(Locked card)
A write-protected SD memory card is inserted.
<SD> Detection error The SD memory card could not be correctly recognized.
<SD> Write error An error occurred when writing to the SD memory card.
<SD> Read error An error occurred when reading from the SD memory
card.
<SD> Delete error An error occurred when deleting data from the SD
memory card.
<SD> File system error An error occurred in File system of the SD memory card.
<SD> Undefined error An error other that the ones above has occurred for the
SD memory card.
IMPORTANT
• In order to be able to correctly use this function, format the SD memory card with the camera before
using it.
• When using SD memory cards that have been used on other devices such as PCs, the correct
information may not be able to be displayed.
• Up to 30 SD memory card logs can be saved to the built-in memory of the camera. When the saved
system logs have reached the maximum number, the newer logs will overwrite the older system logs.
Note
• Refer to our website (http://security.panasonic.com/support/info/) for further information about the
contents of the displayed statuses (relating to the “Viewnetcam.com” service, the UPnP function, or
the self check).
2.12.4 Reset the settings/Reboot the camera [Default reset]
Click the [Default reset] tab of the “Maintenance” page. (®page 41, page 42)
The settings and the HTML data of the camera can be initialized and reboot of the camera can be performed
on this page.
[Reset to the default (Except the network settings)]
Click the [Execute] button to reset the settings to the default. Note that the network settings will not be reset.
It is impossible to operate the camera for about 3 minutes after the initialization.
Operating Instructions 211
2 Settings
To Next Page
Loading...
