• “Mic input interval (Camera to PC)” is unavailable when “AAC-LC” is selected for “Audio input encoding
format”.
[Audio output volume (PC to Camera)]
Select a volume level on the camera to hear audio transmitted from the PC.
High/ Middle/ Low
• Default: Middle
[Audio output interval (PC to Camera)]
:
Select an interval for audio transmission from the following.
160ms/ 320ms/ 640ms/ 1280ms
• Default: 640ms
Note
• When a shorter interval is selected, the delay time will be shorter. When a longer interval is selected,
audio interruption may be diminished even though the delay time will be longer. Select the interval
according to the network environment.
• Audio may temporarily be interrupted and noise may be heard when multiple users are accessing the
camera concurrently. It may be possible to diminish the interruption or noise by setting a longer interval
for “Audio output interval (PC to Camera)”.
• Audio may sometimes not be heard depending on the network environment.
[Audio output duration]
:
Configure the maximum duration for each time audio is outputted.
1min/ 2min/ 3min/ 5min/ 10min/ 20min/ 30min/ 1h
• Default: 5min
Note
• Audio output stops when the specified time has passed. To turn the audio transmission function on,
click the Audio output button again.
[Audio output port (PC to Camera)]
:
Enter the transmission port number (the port number on the camera used to receive audio data transmitted
from the PC).
Available port number: 1024-50000 (Only even numbers are available.)
• Default: 34004
Note
• The transmission port number entered for “Audio output port (PC to Camera)” will be used only when
“Unicast port (MANUAL)” is selected for “Transmission type” (®page 93). When “Off” is selected for
“Stream transmission” (®page 89) or when “Unicast port (AUTO)” or “Multicast” is selected for
“Transmission type”, it is not necessary to enter the transmission port number.
Live page
[Audio input encoding format]
Select the audio input encoding format to be used in the “Live” page from G.726, G.711, or AAC-LC.
• Default: G.726
Note
• G.711 is available only when the “Mic Input (To PC)” is selected for “Audio transmission mode”.
• G.726 is always applied for the audio transmission encoding format.
122 Operating Instructions
2 Settings
To Next Page
Loading...
