8
)
-F;@@56)'(,)/@:9F;A>6)'9JBA4)
The !>I56)and *9L19 LED lights indicate the scanner and Wi-Fi status, depending on the action,
as specified below:
The scanner is off (LCD screen is off).
The scanner is connected to the computer via a
microUSB cable; “USB” will be displayed on the LCD
screen.
Initializing system and storage space/memory card; wait
until the initialization process is complete before using
the scanner.
Scanning error or scanning too fast, refer to Error Codes
on Page 42.
Solid green,
Solid orange,
or Solid red
(based on
selected
resolution)
A. The scanner is off and in charging mode; green
indicator will turn off when battery is fully charged.
OR
B. The scanner is on and you pressed the to
perform a scan. The selected scan resolution is
displayed on the LCD screen.
Blinking blue
every 3
seconds
Wi-Fi Ready for connection to your device
Device is connected to scanner via Wi-Fi
Blinking blue
1 Second/Fast
Browsing or downloading photos
-A>6;J5).;D;F9AE)
&89=AL9@)-A>6;J5
The scanner’s built-in storage disk has approximately 128MB of space that can be used to
store scanned images. Scanned image files are automatically stored in the built-in storage
until it is recognized as full (i.e., less than 2MB remaining for the 300 DPI setting, less than
5MB remaining for the 600 DPI setting, and less than 15MB remaining for the 1200 DPI
setting).
The table below shows the estimated average number of JPG images that can be stored on
the 128MB built-in storage disk:
JPEG
(Est. # of
Files Stored)
To Next Page
Loading...
Need help?
General
