640 Icon LCD Keypad 11n
5.5 Force Arming
Force arming allows you to arm your system while zones are still
open. As the system arms, it will ignore any open zones. Once the
the system is armed, it will then arm all open zones as soon as they
close. Only user access codes with the Force arm option enabled
can Force arm the system.
This feature is commonly used when a motion detector is protecting
an area occupied by a keypad. When Force arming, the motion
detector will remain unarmed (open zone will be ignored) until you
exit the area that it protects. The system will then arm the motion
detector after the zone is closed.
How do I Instant arm?
1. Enter your [
ACCESS CODE].
2. Press the [5] key.
3. If you have access to more than one area, press the number
key representing the area you want to arm or press the [0] key
for all assigned areas. After the confirmation beep, the Exit
Delay Timer will begin. The Instant arm icon (or the affected
area numbers) will flash.
4. Once the system has armed, the Instant arm icon will
illuminate with the armed areas .
DGP2640_EU00.fm Page 11 Friday, April 8, 2005 11:28 AM
To Next Page
Loading...
Need help?
General
