20 User Guide
7.2 User Access Codes
Your keypad is compatible with both DGP-848 and DGP-NE96
systems. With a DGP-848 system, this keypad can support up to 96
user access codes using 2-digit code values (02 to 96). With a
DGP-NE96 system, this keypad can support up to 999 user codes
using 3-digit code values (002 to 999). In both systems, code 01
(DGP-848) and 001 (DGP-NE96) is a System Master Code.
User access codes can be programmed with various options, which
will allow you to control the access to your system. Only the System
Master Code and codes with the Master feature enabled can program
user access codes with their User Options and Area Assignment.
You cannot set options for (or create users with access to)
areas that you do not have access to.
How do I program a user access code?
1. Enter your [
SYSTEM MASTER CODE] or [ACCESS CODE] with
Master feature.
2. Press the [0] key to enter the User Programming Menu.
3. Press the [] key.
4. Enter the 2-digit user number (02 to 96 for DGP-848) or 3-digit
number (002 to 999 for DGP-NE96) that you wish to program.
5. Enter a user code. If you do not want to change an existing one,
press the [] key. Your keypad will emit a half beep when it
switches to User Options. Pre-existing options will illuminate.
6. Program the User Options (Table 4 on page 21) by turning the
options ON or OFF. When options are set, press the [] key
or the [
S] key. Your keypad will emit a half beep as it switches to
Area Assignment. Pre-existing assignments will illuminate.
7. Program the Area Assignment (Table 5 on page 23). An area is
assigned when the corresponding icon appears on the screen.
When finished, press the [] key or the [
S] key.
DGP2640_EU00.fm Page 20 Friday, April 8, 2005 11:28 AM
To Next Page
Loading...
Need help?
General
