18 User Guide
The zones that were in alarm will remain in the Alarm Memory
until the next time that area is armed.
7.0 Access Codes
Access codes are codes that will allow you and others to access the
system. These codes can be programmed to permit access to all or
some of the features and areas. Your installer will program user access
codes to be four digits, six digits, or variable from one to six digits in
length. Each digit can be any value between zero and nine. If your
installer programmed your system to accept a variable code length,
you may have to press the [ ] key after entering your user access
code. Only the System Master Code cannot be less than four digits.
7.1 System Master Code
Default: 1234 (DGP-848) / 123456 (DGP-NE96)
The System Master Code will allow you to access every feature as
well as the ability to add, modify, or delete any user access code. We
suggest that you change this code to prevent others from accessing
and changing your options without authorization.
How do I view a list of alarms that occurred?
When the Memory icon is illuminated:
1. Press the [] key. The Memory icon will flash.
2. Zone icons on the left side of the screen will illuminate to
display zones that caused an alarm as outlined in Zone Status
Display on page 8.
3. Press the [] key to exit the Alarm Memory Display. The
Memory icon and numerical light(s) will turn off.
DGP2640_EU00.fm Page 18 Friday, April 8, 2005 11:28 AM
To Next Page
Loading...
Need help?
General
