32 User Guide
11.0 Fire and Burglar Alarms
11.1 Standard Fire Zone
During a fire alarm, the bell/siren will emit an intermittent sound
(
BEEP-BEEP-BEEP) until silenced or reset. If the zone is a standard Fire
Zone, the system can immediately send an alert to your monitoring
station.
The Fire Zone may reset itself once the problem has
cleared. If it does not, simultaneously press and hold the
[]
and [] keys for two seconds or speak to your
installer.
11.2 Delayed Fire Zone
During a delayed fire alarm, the bell/siren will emit an intermittent
sound (
BEEP-BEEP-BEEP) until silenced or reset. If the zone is a
delayed Fire Zone, there is an automatic delay before the system
contacts the monitoring station (see Figure 2 on page 33). This will
prevent unnecessary reporting of false alarms.
If you are unable to cancel the fire alarm, the system will send
an alert (if connected). Call your monitoring station to advise
them of the false alarm.
How do I disarm the system if it was accidentally triggered?
1. Enter your [
ACCESS CODE].
2. Call your monitoring station quickly to advise them of the false
alarm.
DGP2640_EU00.fm Page 32 Friday, April 8, 2005 11:28 AM
To Next Page
Loading...
Need help?
General
