EasyManua.ls Logo

PARAMOUNT BED 7B01001000A3 - BED EXIT ALARM (PA-H 631*, PA-H 633* Only)

PARAMOUNT BED 7B01001000A3
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
53
2 FUNCTIONS AND OPERATIONS
BED EXIT ALARM (PA-H 631*, PA-H 633* only)
gThisfunctionmeasuresloadchangesonthebedwithsensorsbuiltintothebedandnotiesthe
statusofapatientwhomayfallo󰀨orfalldown.
gThefollowingnoticationfunctionscanbeusedwithBEDEXITALARM.BEDEXITALARMcauses
analertwhenitdetectsthepatient’smovement.Alsoanoticationcanbemadetothenursecall
system by connecting it to the nurse call wall plate with a nurse call relay unit (accessory) (“relay
unit”) or a bed communication cable.
n MONITORING
n LEFT BED
n EDGE OF BED
n SIT-UP
Each function is set using the relay unit. For connecting to the nurse call system and details on handling,
see “Connecting the bed communication cable” (see p. 48) or the instruction manual for the relay unit.
g If a power failure occurs, all bed functions including BED EXIT ALARM stop, so the patient status
cannotbenotiedbyBEDEXITALARM.Ifnecessary,connectthepowerplugofthebedtoanemer-
gency power supply.
Note!
n This product is just an assisting device to detect out-of-bed and does not guarantee safety.
Afalsenoticationorabsenceofnoticationmayoccurdependingonthemotionorlying
position of the patient. We assume no responsibility whatsoever for any damages resulting
from an accident, etc.
n The bed communication cable and relay unit may not be suitable depending on the type of
nurse call system. For details, contact Paramount Bed (see p. 118) or your distributor.
nTouseBEDEXITALARM,youneedtosetthenoticationfunctionsettings(forthesetting
procedure, see the instruction manual for the relay unit).
nBeforeusingBEDEXITALARMforthersttimeafterthebedisinstalled,makesurethat
noticationismadecorrectlybeforeuse.
nIf notication is not made or any other errors occur, stop using BED EXITALARM and
check the bed and bed communication cable, or relay unit by referring to “1. Troubleshoot-
ing” on p. 95 to 98.
nIfyouturnthenoticationfunctiononwhilethebedheightislessthan“+4cm”fromthe
minimumheight,thebedrisestothe“minimumheight+4cm.”

Table of Contents

Related product manuals