Pari eFlow rapid - D Charging Your Controller

D Charging Your Controller
10 eFlow
®
rapid nebuliser system – Questions about your device? Contact your service partner
D Charging Your Controller
The controller runs with an integrated battery pack and can be recharged at any time.
Using the power supply: The power supply will automatically adjust to the incoming voltage and will charge the
controller‘s integrated battery pack. It can be used worldwide, but may require changing the country-specific adapter.
Step D1 To change the country-specific adapter (a),
press the clip (b) and slide the country-specific
adapter upwards. Slide on the new country specific
adapter until the clip connects.
Fig. D1
Step D2 Plug the power supply into the controller.
The power cord socket is located on the top of the
controller. Push the end of the power supply cord
into the power cord socket (a). Do not attempt to
insert the power cord into the bottom of the
controller.
Fig. D2
a
b
a