Notes on the Documents Supplied
4 192-120102 N7 - February 2004
1.1 C3 ServoManagers
The Compax3 ServoManager can be installed directly from the Compax3 CD.
Click on the appropriate hyperlink or start the installation program
"C3Mgr_Setup_V.... .exe" and follow the instructions.
Minimum requirements
For successful installation, your PC must meet the following minimum
requirements:
! Windows 98, Windows Me, Windows NT 4.0 (Intel) with Service Pack 6, Windows
2000 or Windows XP.
! Administrator authorization* on the system
! Microsoft Internet Explorer 4.01 (SP2) or higher
! Pentium-PC (300 MHz or faster is recommended)
! 64 MB RAM (128 MB recommended)
! Required HD capacity
♦ CD-Installation: 350 MB before installation, 200 MB after installation
! Super VGA-Monitor (with a resolution of at least 800 x 600, setting: small fonts)
* you do not need administrator authorization for an update version!
Your PC is connected with Compax3 over an RS232 cable (SSK1) (COM ½
interface on the PC based on X10 Compax3).
Start the Compax3 ServoManager and make the setting for the selected interface
in the menu Options: Port (RS232) COM 1 or COM 2.
In the menu tree under device selection you can read the device type of the
connected device (Online Device Identification) or select a device type (Device
Selection Wizard).
Then you can double click on "Configuration" to start the configuration wizard. The
wizard will lead you through all input windows of the configuration.
Installation of the C3
ServoManager
Connection between
PC and Compax3
Device selection
Configuration
To Next Page
Loading...
Need help?
General