K3.1.142e Manual NitroFlow Lab - 10 -
• The NitroFlow
®
Lab is not designed for installation in
an Exx-classified area.
• Do not install the NitroFlow
®
Lab in an area where
explosive mixtures may occur.
2.3 Electricity
Warning
• Only service-engineers, qualified to work on electrical
equipment, are allowed to do the installation,
maintenance and repairs.
• Disconnect the main power supply before you do the
maintenance or repair.
• If a service-engineer has to work on the NitroFlow
®
Lab while the electric power it is connected, the
service-engineer must be very careful with respect to
the electric hazards.
2.4 Safety precautions
Warning
• Make sure that the ventilation rate is sufficient in the
room where the enriched oxygen is ventilated, or lead
the enriched air outside. Keep the ambient
temperature between 10 and 35 °C.
• Install the peripheral equipment, piping and nitrogen
storage vessels according to standard procedures.
Parker Filtration & Separation B.V. cannot take
responsibility for this.
• Do regular maintenance to the NitroFlow
®
Lab, to
ensure proper and safe operation. Refer to chapter 8.
• Make sure that instructions concerning health and
safety are compliant with the local legislation and
regulations.
To Next Page
Loading...
