K3.1.142e Manual NitroFlow Lab - 43 -
Error Possible cause Possible solution
Purity setting has changed
over time
Readjust purity (refer to §7.3)
Leak in piping Check for leaks in the piping.
Generator
shuts down
and goes to
stand-by
Reached pressure limit
setting, if option activated
Reset pressure switch limits
or deactivate option (refer to
§6.3.3)
Display
message
with audible
alarm
Outside of preset parameter
limits
Refer to § 8.2
Table 8-1: Error list
8.2 Alarm messages
When the Nitrogen Out symbol (A) in the main screen is flashing, it
means that an alarm is occurring. To see which alarm is occurring, touch
the symbol for more information.
Default all alarms that can be set, are set to NO. This
means they are not activated
.
What happens Alarm description Default
Oxygen level too high O2 high Off
A
To Next Page
Loading...
