K3.1.142e Manual NitroFlow Lab - 44 -
Oxygen level too low O2 low Off
Inlet pressure too high P-inlet high Off
Inlet pressure too low P-inlet low Off
Outlet pressure too high P-outlet high Off
Outlet pressure too low P-outlet low Off
Inlet temperature too high T-inlet high On
Inlet temperature too low T-inlet low On
Membrane pressure sensor fails P-mem sensor fail On
Outlet pressure sensor fails P-Outlet sensor fail On
Inlet temperature sensor fails T-Inlet sensor fail On
Status of temperature of
compressor box 1
Temp comp1 On
Status of temperature of
compressor box 2
Temp comp2 On
Oxygen sensor needs to be
calibrated
Calibrate O2 cel On
When an alarm is displayed there are two options:
1. Accept
2. Reset
When ACCEPT is touched, the alarm sound will disappear while the alarm
level is still exceeded. If the alarm is not resolved the alarm message will
appear again in 24 hours. This function gives you some time to work on the
solution.
When RESET is touched the alarm status is cleared. However, if the alarm
still exist it will appear again after the delay time that has been entered in
the alarm settings menu
(refer to § 6.3.2) has passed.
To Next Page
Loading...
