K3.1.142e Manual NitroFlow Lab - 21 -
5.3 Unpack and check equipment
• Open the packaging per instructions on the crate.
• Make sure that all components are delivered. Refer to § 4.1.
5.4 Connect nitrogen consumer
Warning
• Do not connect the power at this time.
• Make sure that the inlet and outlet tubes are free of
dust, particles, metal parts and curls, liquids and
grease before you connect the NitroFlow
®
Lab.
Connect the product outlet to the application.
5.5 Connecting power
1. Connect the mains plug to a suitable wall socket with earth connection
2. The control system has in- and output contacts for remote control and
alarm signaling (refer to §5.6).
Warning
The main supply line voltage must be within 10% of
nominal rated voltage for the generator. In case of larger
variations the NitroFlow Lab will stop; continued use
under these circumstances will inevitably lead to motor
damage.
To Next Page
Loading...
