Parker SPD 2 - Programming the Drive by PC

Parker Hannifin S.p.A. - Divisione S.B.C. “SPD” User’s Manual
74
11 Programming the drive by PC
It is available a serial kit is supplied to enable communication between a PC and the drive.
The kit includes an RS-422/RS-232 converter, relative 230V~ power supply and serial
connection cable. The enclosed communication software (supplied free of charge) designated
MotionWiz has the following HW/SW requirements: PII microprocessor or higher,
*Windows98 or more recent version, mouse and serial port for drive connections. The main
features of Motion Wiz are:
- serial connection of up to 32 drives
- reading and setting of basic parameters and drive commands
- reading and setting of commands and parameters of operating modes
- functional block diagrams
- pico-PLC program displayed as text format
- display of pico-PLC program status during operation
- I/O status
- file storage of parameterisation including pico-PLC program
- uploading of parameterisation including pico-PLC program from a file that can be selected
from among those previously stored
- oscilloscope function
To create line load (burden) resistances, jumper pins 2 and 6, and pins 4 and 7 on connector
X3 of the last drive on the serial line.
*Windows and the Windows logo are registered trade marks or trade marks owned by Microsoft Corporation in the United States of America
and/or other countries.
RS-232
RS-422
17
2
14
5
7
1
2
3
4
8
DB9 DB25
2
3
7
3
2
5
Serial link
personal computer
tx
rx
0V
CL-422
refer to text for burden resistors