27 MIC 1161 Manual
CONTROL ---- PROGRAM ---- SETUP
(Ctrl) (Prog) (SEt)
If a mode is not enabled it will be skipped over by the routine.
3.2.1 ENABLE MODE
The Enable mode provides a means of enabling or disabling access to the
Program and Set-Up modes. Also found in the Enable mode is the current
code value for the LOC/ULOC feature. The code may be modified here by
using the UP/DOWN keys when the code is displayed.
If a mode has been disabled, then that mode will not be displayed or avail-
able to the user in the Control mode. See Table 3-1 (below) for the Enable
mode procedure.
3.2.2 PROGRAM MODE
The Program mode is used to configure or re-configure the instrument.
The input and output selections are made in the Program mode. All pos-
sible parameters are illustrated in Table 3-2 (page 28). Only those param-
eters that are applicable to the hardware options chosen will be displayed.
3.2.3 SET-UP MODE
The Set-Up mode is used to adjust the setpoint, make alarm settings and
retransmit scaling needed for proper operation of the instrument. See
Table 3-3 (page 30) for the Set-Up mode. Only those parameters that are
applicable will be displayed.
TABLE 3-1 ENABLE MODE
To enter the Enable mode, press and hold the UP and DOWN keys. The
display flashes for about 5 seconds, then returns to a normal display for
about 5 more seconds, then displays "EnAb". Release the keys, the dis-
play should show "EPro". Pressing the DOWN key will display the Enable
mode codes in the following sequence:
EPro - - ESEt - - Loc
(Continued on next page)
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
