7 MIC 1161 Manual
Installation and Wiring 2.1
Electrical code requirements and safety standards should be observed and
installation performed by qualified personnel.
The electronic components of the instrument may be removed from the
housing during installation. To remove the components, grip the side
edges of the front panel and pull the instrument forward. During re-installa-
tion, the vertically mounted circuit boards should be properly aligned in the
housing.
Ensure that the instrument is correctly orientated. A stop will operate if an
attempt is made to insert the instrument incorrectly.
CAUTION: This stop
can be over-ridden with enough force. If in doubt, check orientation
again!
Recommended panel opening sizes are illustrated in Figure 2-1, page 8.
After the opening is properly cut, insert the instrument into the panel open-
ing. Ensure that the panel gasket is not distorted and that the instrument is
positioned squarely against the panel. Slide the mounting clamp into place
on the instrument (see Figure 2-3, page 9) and push it forward until it is
firmly in contact with the rear face of the mounting panel.
Note: The mounting clamp tongues may engage either on the
sides or the top/bottom of the instrument housing. Therefore, when
installing several instruments side-by-side in one cut out, use the
ratchets on the top/bottom faces.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
