Partner SP-600-A - Figure 2.10 Parallel Port Configuration Sub-Menu; Parallel Port Configuration

20 CHAPTER 2 BIOS SETUP
Parallel Port Conguration
Figure 3.10 Parallel
Port Conguration
sub-menu
Parallel Port
This item allows you to enables or disables the parallel port.
Change Settings
This item allows you to specic IO address and IRQ for the parallel port.
Device Mode
This item allows you to set the data transfer protocol for the parallel port. There are four options: Standard
Parallel Port Mode, EPP Mode (Enhanced Parallel Port), ECP Mode(Extended Capabilities Port), and ECP
& EPP Mode. The default setting is Standard Parallel Port Mode. Extended Capabilities Port (ECP) and En-
hanced Parallel Port (EPP) are bidirectional modes, allowing both data input and output. ECP and EPP modes
are only supported with EPP- and ECP-aware peripherals.