Lines should be indented with tabs.
Where hostname is the device name of a MFP Server, the ht=1 tag
specifies the hardware type is Ethernet, the ha= tag specifies the Ethernet
address of a MFP Server, which is the Node ID located on the MFP Server.
The ha tag must be preceded by the ht tag. The ip= tag should correspond
to the IP address you want to assign to the MFP Server.
For example, a MFP Server with the following configuration:
Node ID: 0000B4010101 (this implies Ethernet address is 0000B4010101),
IP address: 203.66.191.12
The entry for this MFP Server in the /etc/bootptab file should be:
MF010101:\
:ht=1:\
:ha=0000B4010101:\
:ip=203.66.191.12:
1.2.3. Verify Mini-101M's IP Address
To verify your MFP Server is responding to the newly assigned IP address
using a PING command:
ping ip-address
&RQÀJXUH5HPRWH/3'3ULQWLQJ
on the Host
The procedure you use to configure your Unix/Linux host(s) to allow
printing to your network remote MFP Server varies between different
varieties of Unix/Linux. The procedure below can be used for Unix/Linux
variants that are related to BSD Unix, such as SunOS or Linux. For other
versions of Unix/Linux, consult your system documentation, keeping in
mind that:
To Next Page
Loading...