Pendulum CNT-91R Programmer's Handbook

Device specific errors
Error
Number
Error Description description/explanation/examples
(1)100
Device operation
gave floating-point
underflow
A floating-point error occurred during a counter op
-
eration.
(1)101
Device operation
gave floating-point
overflow
A floating-point error occurred during a counter op
-
eration.
(1)102
Device operation
gave ‘not a number’
A floating-point error occurred during a counter op
-
eration.
(1)110
Invalid measure
-
ment function
The counter was requested to set a measurement
function it could not make.
(1)120
Save/recall memory
protected
An attempt was made to write in a protected mem
-
ory.
(1)130
Unsupported com-
mand
Indicates a mismatch between bus and counter ca-
pabilities.
(1)131
Unsupported
boolean command
(1)132
Unsupported deci-
mal command
(1)133
Unsupported enu-
merated command
(1)134
Unsupported auto
command
(1)135
Unsupported single
shot command
(1)136
Command queue
full; last command
discarded
The counter has an internal command queue with
room for about 100 commands. A large number of
commands arrived fast without any intervening
query.
(1)137
Inappropriate suffix
unit
A suffix unit was not appropriate for the command.
Recognized units are Hz (Hertz), s (seconds), Ohm
(W) and V (Volt).
(1)138
Unexpected com
-
mand to device exe
-
cution
A command reached counter execution which
should have been handled by the bus.
(1)139
Unexpected query
to device execution
A query reached counter execution which should
have been handled by the bus.
(1)150
Bad math expres
-
sion format
Only a fixed, specific math expression is recognized
by the counter, and this was not it.
Error Messages
Error Code (1)100 to (1)150 7-13

Pendulum CNT-91R Specifications

General

Brand	Pendulum
Model	CNT-91R
Category	Measuring Instruments
Language	English