Introduction
Power Center Overview
The IntelliChlor™ system comprises of a Power Center and electrolytic Cell. The Power Center converts AC
electrical current to a low voltage DC current required by the IntelliChlor electrolytic cell to operate and create
chlorine for the swimming pool and spa. The Power Center is connected with the pool circulation pump
electrical source so that the electrolytic cell only operates when the pool pump is on. It is recommended that a
pool pump timer be used to save on energy and prolong the service life of your pool pump and IntelliChlor. A
timer is not included as part of the Power Center kit. The IntelliChlor Power Center can be connected to an
IntelliTouch system for automation control.
The Power Center enclosure can be mounted vertically on a flat surface such as a wall or post no more than
4.57m (15 feet) away from the cell controller. The Power Center houses the transformer, fuse, and connector
to the cell. 110 VAC and 220 VAC wiring is connected at this box, with 35 VDC output to the cell controller.
A 10 AMP “3AG” Style fuse is mounted on the bottom of the enclosure for additional protection. There are no
other controls or lights on the outside of the Power Center. A green power LED indicator is mounted on the
inside main board. When the Power Center is switched on, the power LED is lit.
Transformer
Internal
Ground lug
Attach incoming AC wire
to Power Center AC
power wires
Lug (Ground bonding)
Screw terminal to
EasyTouch and
IntelliTouch
systems
Power LED
indicator
Fuse (10 AMP)
Cell connector
IntelliChlor Models
IntelliChlor Power Center (model PC 100)
(cover removed)
The IntelliChlor salt chlorinator system models are
• PC 100 (P/N 520556): IntelliChlor power center kit.
• IC20 Cell (P/N 520554, 520911, EC-520911): Designed for pools up to 72,000 Litres, the cell will produce
approximately
0.22 Kg of free available chlorine per 24 hour period. This cell uses two terminal blades and
five bi-polar blades, making this system more cost competitive.
• IntelliChlor pass-through cell (P/N 520588): For new pool start-up.