To Next Page

To Previous Page

IntelliTouch ScreenLogic User’s Guide

Dim Lights

Lights that have dimming functionality can be dimmed from the Lights screen. Only incandescent tungsten filament

lights may be dimmed. SAm, SAL, IntelliBrite, Fiber-optic, or Halogen lights cannot be dimmed. The feature circuit

must be assigned a dimmer circuit function. To assign a circuit function, see “Assign a Circuit Name and Function,“

page 38. In order to dim lights, the Dimmer Module (P/N 520406) must be installed by a qualified electrician in the

Load Center.

To dim lights:

1. From the Main screen, tap the Lights tab.

2. Tap one of the Dimmer buttons to set the dimming level for the light. Dimmer percent values are from 30% to

100%. The light will adjust to the set dimming level.

Note: Macros can turn on light dimming circuits, but lights cannot be dimmed through the macro.

The dimming level must be changed for each light dimming circuit.

emaNnoitpircseD

snottuBsthgiLlaicepS otsnottubsthgiLlaicepSehtrofdna,neercssihtniyalpsidotsthgilroF

eromr

oF.golaidsthgiLlaicepSehtnithgilehtngissatsriftsumuoy,krow

.53egap,)5fo2petS(stiucriCputeSotrefer,noit

amrofni

:ffOllA laicepSehtnidengissaneebevahtahtsthgilllaffosehctiwS

.)53egapees(ytiliturotarugifnoCehtf

o2petsnigolaidsthgiL

:nOllA laicepSehtnidengissaneebevahtahtsthgilllaffosehctiwS

.golaidsthgiL

:teSroloC evahtahtsthgilskrowREBIFdna,LAS,MASllanosehctiwS

.golaidsthgiLlaicepSehtnidengissaneeb

:cnySroloC dna,LAS,MASllaroferutaefcnySroloCehtsetavitcA

.golaiDsthgiLlaicepSehtnidengissaneebevahtahtsthgilskrowrebiF

:miwSroloC dna,LAS,MASllaroferutaefmiwSroloCehtsetavitcA

.golaidsthgiLlaicepSehtnidengissaneebevahtahtsthgilskrowrebiF

:raBsutatSedoMroloC dnasutatsnoitavitcaehtsetacidnirabderehT

roloCro,cnySroloC,teSroloCehtgnitavitcA.emitnoitelpmoctnerruc

ehtrofetunimenootpuekatnacti,etaidemmitonsiserutaefmiwS

.etelpmocotssecorp

Lights Screen (Continued)

Pentair Intellitouch ScreenLogic User Manual

Questions and Answers: